Obtaining functional-gradient Ti-HA coatings by detonation spraying

Authors

  • Zh.B. Sagdoldina
  • D.R. Baizhan
  • Е.Е. Kambarov
  • K. Torebek

DOI:

https://doi.org/10.31489/2022ph3/43-51

Keywords:

detonation spraying, functional gradient coatings, phase composition, mechanical properties, hydroxyapatite, titanium, wear resistance, roughness

Abstract

Functional-gradient titanium/hydroxyapatite (TiHA) coatings were obtained using detonation spraying technology to improve the structure and mechanical properties. To obtain functional-gradient coatings, pulsed energy sources are best suited, namely, detonation spraying, in which the energy of the explosion of gas mixtures is used as a source of pulsed action. By controlling the modes of detonation spraying, it is possible to vary the temperature and rate of coating deposition; accordingly, it is possible to obtain a certain structuralphase structure of the coatings. The structural-phase state and tribological properties of TiHA detonation coatings were investigated by modern materials science methods: X-ray phase analysis (XRD), scanning electron microscopy (SEM), energy dispersive spectroscopy (EDX-mapping), profilometry and ball-disk wear-resistance test. The results showed that the coatings had a continuously gradient elemental composition across the cross-section of the coatings with no boundary between the elemental layers of the coatings. The amount of Ti gradually decreased and the amount of hydroxyapatite gradually increased in the direction from the substrate to the surface of the coatings, which allows to expand the possibilities of using TiHA-coatings for bone implants. Since the surface layer is composed of HA, the resulting functional-gradient coating demonstrates excellent biocompatibility and the ability to create new bone tissue. The excellent mechanical strength of the functionally graded coatings is ensured by the Ti phase.

Additional Files

Published

2022-09-30

Issue

Section

TECHNICAL PHYSICS

Received

2023-11-23